Heat pump water heater vs tankless: which fits your household?

Tankless heats water on demand; a heat pump water heater stores it and qualifies for rebates. Compare hot water use, gas, vent and panel needs for each.
Tankless gives you continuous hot water and saves space. A heat pump water heater stores hot water in a tank, runs on electricity and can qualify for rebates. The better fit depends on how your household uses hot water.
Both are upgrades over a standard tank, which is why the choice can be hard. This guide compares them on the points that matter most. Our tankless water heater page and heat pump water heater page cover each service in detail.
How do a heat pump water heater and a tankless heater differ?
A tankless heater warms water only as it flows, so there is no tank to run out. A heat pump water heater keeps a tank warm by pulling heat from the surrounding air. One heats on demand; the other stores.
- Tankless (on-demand). When you open a hot tap, water flows through a heat exchanger and is heated on the spot. ENERGY STAR notes that heating water only when it is needed cuts water heating costs while still providing continuous hot water. Most whole-home tankless units in homes run on gas.
- Heat pump water heater. A fan pulls room air over a coil, and a compressor moves that heat into the tank. It is electric, and most models have backup elements for high demand.
Space is the other big difference. A tankless unit mounts on a wall and frees up floor space. A heat pump water heater is a tall tank that needs a room with plenty of air around it. Our guide to how heat pump water heaters work explains the placement rules.
Which suits a household that uses a lot of hot water at once?
It depends on the pattern. Tankless never runs out, but it can only heat so many gallons per minute at once. A heat pump water heater can serve several fixtures together until its stored supply runs low.
Tankless units are rated by how many gallons of hot water they produce per minute, often written GPM. ENERGY STAR lists rough demand figures for common uses:
- Shower or bathtub: about 2.5 gallons per minute.
- Clothes washer: about 3.3 gallons per minute.
- Kitchen or bathroom sink: about 2.2 gallons per minute.
- Dishwasher: about 1.3 gallons per minute.
Add up what might run at the same time. Two showers and a dishwasher is more than one shower and a sink. A tankless unit sized for your peak keeps up; one sized too small runs lukewarm when demand stacks up.
A heat pump water heater works differently. A household that uses hot water in long back-to-back stretches, like several showers in a row, can drain the tank faster than the heat pump refills it. Backup elements help, but tank size matters. Here is a rough guide:
- Leans tankless: long showers, spread-out use, a household that has run out of hot water before, or limited floor space.
- Leans heat pump: a household moving toward electric, a good-sized utility room or basement, and interest in rebates.
What does each need from your gas line, vent or panel?
A gas tankless heater needs a gas supply large enough for it and a way to vent combustion gases. A heat pump water heater needs no gas or vent, but it needs an electric circuit and room on your panel.
Tankless needs
- Gas supply. A whole-home tankless unit can need a larger gas line than the old tank. Our gas line installation service can handle that.
- Venting. ENERGY STAR advises that the installer identify how combustion gases will be vented, and whether power is nearby for models with forced ventilation.
- Water quality. Mineral buildup can affect the heat exchanger over time, so periodic flushing is part of ownership.
Heat pump water heater needs
- Electrical capacity. A dedicated circuit and room on the main panel.
- Air and space. A room that stays in a moderate temperature range with plenty of air around the unit.
- A drain for the moisture the unit pulls from the air.
Any gas appliance comes with one safety rule. If you smell gas: Leave your home now. From outside, call Xcel Energy and the fire department. Then call us.
Which may qualify for a rebate?
The heat pump water heater. You may qualify for the Xcel Energy heat pump water heater rebate and the Colorado heat pump tax credit. No rebate is listed for a gas tankless water heater.
- Xcel Energy heat pump water heater rebate (last verified October 1, 2026).
- Colorado heat pump tax credit: at least $83 for a heat pump water heater in 2026 (last verified October 1, 2026).
Amounts depend on your utility, address and equipment. We install only rebate-qualifying equipment and file the rebate paperwork, so you do not have to chase the forms. See our Denver rebates page for the current programs.
For a deeper look at tankless against a standard tank, read water heater options: tankless and traditional. If you are leaning tankless, our on-demand water heater installation guide covers what the install involves.
How do we help you decide?
We look at how your household uses hot water, your gas line and vent, your panel and the space you have, then show you which type fits. You get a written quote for your home after a $0 visit.
- A master plumber on the team. Jimi Knight, our master plumber, is on the team for tankless and heat pump water heaters.
- Panel answers in-house. Our master electrician, Matthew Donizio, can check the circuit a heat pump water heater needs.
- Guaranteed installs. A new water heater install is covered by the Veteran 1-Year Make-It-Right-or-Take-It-Back Guarantee. Conditions apply; the written guarantee is available before you buy. Read the guarantee.
Ready to compare for your home? Book a $0 visit through our tankless water heater page, or see all our water heater installation options. Call (720) 722-1229; we answer 24/7.
Need Help?
Contact us today to discuss your needs. Our team is ready to help.
About the Author
Founder, U.S. Army veteran
More Articles
View All PostsReady to Get Started?
Whether you need a repair, maintenance, or a new installation, our expert team is here to help.


